What Have You Done To Your 3rd Gen Today?

oh nice i was thinking if i do the same as you i'd just put a rope on every box but i like your rod n hook idea to help push it back lol

 

Simple addition to somewhat remedy the awful location of the data port on the dash.


Routes the USB plug 90 degrees down with a USB C port. Now the cord isn’t sticking straight out above the cup holder and I didn’t have to mess around routing usb back and forth from the center console.

Right Angle USB A Male to USB C...

GELRHONR Right Angle USB A Male to USB C Female Adapter,90 Degree USB3.0 to Type C Connector Support unidirectional Sides 5Gbps & Data Transfer-2Pack(Balck Up&Down Angle)

https://www.amazon.com/dp/B08PSCL9FC?ref=ppx_pop_mob_ap_share

 

Camera at the top of the tailgate. So I can have rear view when it is down. Gotta swap the cables though.

 

Not the OP.
I have Billiebars, it is a solid product.
With a cargo carrier and 2x Yakima bike racks mounted on top they takes about 5 min. to remove. I keep a screw driver in my glove box so I can remove the anti-theft screws for the BillieBars if needed in about another 5 min.

 

Ah thanks for the insight. Makes me feel like two dudes and a screwdriver can steal what’s on the bars then in 5 min..

 

Billeibars come with anti-theft SS screws. My bike racks have quick connects but I added an Allen key bolt at the rear tire holder bolted to the BillieBars and also cable locked them.

 

Added OEM TRD grill and OEM garnish. Also raptor lights from R4T. Looks great I think

 

I actually got one that does a right turn out of the USB port. I could kick the a** of the engineer who placed that port right over our cup holders. Ran the cord along the right side of the dash piece and up to the magnetic Phone holder. Held in place a couple of times with the fuzzy part of Velcro, the whole piece over the cord so the adhesive holds the cord.

 

I don't think I can make it to work tomorrow.


Bilstein 8112 with the fresh colors


Tomorrow is the big day

 

I used this video from @ClassyTacos

Protip.... lol Make sure you make the hole low enough to clear the cupholders if needed. I screwed up and made mine too high on the first try.

https://youtu.be/dVwWxehurtY

 

Rosery beads and a cheap motel room key?
Hmmm

 

Lol I noticed that also, Man needed a quick prayer either before or after using that motel key.

 

Something about Missionary position comes to mind.

 

Got my camper shell installed.
ARE CX classic. Long Bed.

 

No way… hahahaha

 

I think there is a thread about this. The one responsible is a member on here.

 

Threw on a used trd skid plate i got.

 

it worried me the first time it happened to me. I had a different vehicle before this and idled all the time at work. Switched to the Taco and freaked out at first lol.