Viper 4105v remote start

i finished installing a remote start. Everything works great except the parking lights and the fact that the truck is still “learning how to idle when shifting from park to drive” but that’s not a worry. The remote start locks and unlocks the doors. Remote starts. Everything was soldered and taped correctly. The parking lights do not flash or stay on when running. The white parking light wire from the module with the 10amp fuse was tapped into the 13pin plug on the fuse box that is ( + ). Is there any reason for the lights not working? The lights work normal when driving.

 

This main harness

 

The following wires. Hood pin not connected

 

I believe I figured it out. The 2015 turns the lights off when the key is off an the doors are open. Therefore it needs switched power to turn that module on. If I tap into the hazards it should allow the lights to flash when locking and unlocking. Hopefully I can figure out a way for them not to flash while remote start running

 

Novice here, looking to do an 4105v install on a 2012 tacoma I'm in need of some guidance as far as where to find the wires to tap into. Thanks in advance!