Trailer Harness extension

Hello, I recently replaced my factory rear bumper on my 18 TRD OR DC with an aftermarket bumper. Once I remounted the 7pin/4 pin connector from my stock bumper the wiring harness is now short due to the new bumper. Anyone know if there is an extension available? Thanks

 

Found what I needed. If anyone runs into this after upgrading their rear bumper I found this from curt manufacturing. I just cut out the four connector plug and was left with the extension I needed plug and play. Gonna shorten it a bit so I can make it up neatly under the bed. Will get pics when i’m Done and post. Thanks

REPLACEMENT OE 4-WAY FLAT SOCKET (T'S INTO USCAR) #55384

 

what was the end result?

 

@Bigdaddy4760

 

Thanks Chris I check it out

 

Nice. Beat me to it.

 

You should have more harness if you cut all the ties holding the harness from the bumper to the tank area... I was able to get plenty to make mine work.... beats having to re-solder everything... Just the Lic. Plate lights

 

What was the end result? I found the same part on etrailer.com, but it says that it is not compatible with a Tacoma? I am exploring this option to add a brake light strip with a 4 pin flat connection to avoid wire splicing. Thanks!

 

I got the same part, and I ended up splitting it , making the wires longer in order to make it fit. but, it works good, and tested it with a test light. cheap way to make it work.

 

Awesome! Thanks!

 

Pics later

 

https://www.etrailer.com/Custom-Fit-Vehicle-Wiring/Tow-Ready/20140.html
More length to play with and all circuits available.

 

Old post but this worked. After adding a HC rear bumper I had the same issue. I was super lazy in trying to re-solder / add extension wires.

I bought exactly what you linked, plugged it in the OE connectors and left the 4 plug. Tested connections at a local U haul. Ready to pull a small trailer again.

 

Op is gone? This is just an easy way for a plug and play extension correct?