Torque Spec Help (Intake System)

Hey everyone, really sorry to ask this but I don't have time to rifle thru for the correct torque specs today and I need to get my truck up and running ASAP. i tried but there were a few conflicting posts and i'm not sure of the name/type of my engine (1GR-FE?)

can anyone take pity on me and provide me the torque specs for an automatic 2012 Tacoma SR5 V6 for the following parts (all from the knock sensor harness repair process):

-intake manifold (10 t40 bolts, i'll be using an extension rod and found the converter link)
-fuel bar (6 long 10mm bolts)
-plenum-to-intake mount (4 8mm allen bolts, 2 12mm nuts, i'll be using an extension rod for the two driver's side ones)
-throttle body (4 long 10mm bolts)

i don't think there's anything else that is critical that i touched beyond hoses, sensor plugs, and the perimeter plenum mounts.

thanks so much!

 

bump. i've seen 21Nm or 13ftlbs for all those bolts

 

Have you tried here?
https://www.tacomaworld.com/threads/the-torque-spec-guide.318116/

 

yea, i tried to find it in there but i'm not sure of the name/type of my engine and all those are for an '06. are those universally applicable?
if i'm right with my engine type being the 1gr-fe, would page 124 of the PDF in that be the right set?

if so, i'm seeing the following:
-intake manifold (10 t40 bolts, i'll be using an extension rod and found the converter link) 26Nm / 19 ftlb
-fuel bar (6 long 10mm bolts) 15Nm / 11 ftlb (page 141)
-plenum (intake air surge tank?)-to-intake mount (4 8mm allen bolts, 2 12mm nuts, i'll be using an extension rod for the two driver's side ones) 28Nm / 21 ftlb
-throttle body (4 long 10mm bolts) edit: on page 132, 11Nm / 9ft lb
-perimeter plenum mounts/"surge tank stay" & "throttle body stay" 21Nm / 15 ftlbs

 

Looks right, except this says 16 ft/lb for stays.
I personally just “went by feel” on mine.

https://chrometrucknutz.org/05FSM/data/ileaf/06toyrm/06toypdf/06rmsrc/rm2006ta/009001.pdf

 

thank you, i appreciate the help and input

 

those are all correct.

 

16-22 or so is probably fine all around. All you have to do is squeeze those little rubber seals a little