Tacoma on 33x10.5 boggers

Took 2 months but I got the 3” daystar lift almost fully installed. Broke a bolt because I was using a faulty torque wrench so I’ll have to go buy one of those. But here s a couple pics of how it sits right now. I’m gonna get the bumper on and maybe take the 1” block out of the rear end or throw horse stall mat in the bed to get the ass end down a little more but I’m happy with it.

All I have to do now is get an extension welded onto my stickshift and replace that bolt I broke. Other than that just small stuff I think.

After:
Before:

 

Backed up with school n work but it’s only a matter’a time beforei get these guys in

 

Single cab on boggers, I can definitely dig it. Got a set of 15x12’s wrapped in 33x12.5 boggers waiting to get put on my truck.

 

Love the look, great job!

 

I've been so busy dudes. I installed the rear gears and got a slight whine so i got paranoid. Literally shipping the differentials out TODAY to ECGS just to get the shit handled before winter. Im too busy and only have one vehicle. Although i feel i did everything basically perfectly i STILL got gear whine during deceleration. So i want their feedback on how i set stuff up. Its spooled in the rear and getting an ARB in the front. Might as well do it while im in there...

 

5.29s are in along with the ARB iand the compressor.

On my second test run I took the truck up to 60 mph on flat ground averaging 2600-2650 RPM on my 33s (275/60/20).

So at 70 I’ll probly be around 3100 R’s which is 100 less than I anticipated I’d be so I’m stoked on that. Honestly couldn’t be happier. Truck has good low end torque and should get way better mileage now.