Tacoma armrest leather swap

Looking to do the swap out for the TRD offroad to leather for the center armrest cover. Anyone done this yet? This is the site i was looking to buy from. The rubberized top is fine but thinking this would complement leather seat covers or the OR/Premium trim.

https://leatherseats.com/shop/inter...d/24-toyota-tacoma-console-lid-cover-buckets/

 

I don't know the part number readily, but if you find the part number for the console arm rest, the Limited variant comes in the dark gray/black softex.

Looks like the top is going to be variants of part# 58905-AK0%
or the entire console box as variants of part#58910-AK0%

 

for some reason I completely spaced they have a version of the black softex in there. I thought it was exclusively boulder. I'm getting ready to take my truck in for the one year maintenance tomorrow, i'll see if i can track that down the part number in the meantime too. Would much rather swap it if it's already attached and i can just screw the lid versus the link above. Cheers!

 

It looks lighter in the photo, but you can see how the color aligns to the black plastic console. This is from my truck.

 

Lots of choices!

 

@BaltimoreMD thanks for that photo. This is perfect, i'll message the Toyota of Decatur folks and see if they can find the P/N. Their parts division seems to have some of the best discounts if I am ordering stuff.

@Booman yeah! It's actually pretty neat if you're looking to customize your own. I was about to do that and try to match until Baltimore linked the factory part on the limited!

 

For any interested that may do this in the future also! part number for that armrest lid. I just got it confirmed with a parts manager.

58905-AK020-c4

 

Follow-up after I received and got this thing installed. As an FYI for anyone else who may be looking to do this, the part number above did not fit my 4th gen plug and play. The lid screw holes and clips were off to fasten it back to the lid. I suspect that may be due to possibly getting an armrest lid for a hybrid because dimensions are slightly different iirc. Either way, it was mostly a non-issue as I pulled leather/pad off the new and re-applied it to the existing.

 

@Weap0nR so you just took off the top part of each and swapped them? The first link from the aftermarket company I was going to do that but when you watch there install video it seems like you would almost need an upholstery shop to do it to make sure it was perfect with no wrinkles. This would be better if it was simple an unbolt, swap and bolt back on or did you actually need to remove just the leather and re upholster it?

 

Sadly it was not just a simple swap. I should've clarified that better earlier, apologies. I did have to remove the leather and re upholster. I stapled it back to where the staples initially went through from pulling it off the original.

Ultimately it'd be the same process outlined in the vendor video. If i had to do it all over again, i'd probably order straight from leatherseats.com since the stitching color doesn't match.