Switch Pros 9100 programming

I have a SP 9100 installed. I have the #1 trigger wire connected to high beams and #2 to reverse lights. I have read the instruction sheet, but am still thoroughly confused how to program an accessory (switch pro switch) to be triggered.

Anyone have a link to detailed instructions or care to explain it.

Thanks

 

Instructions from switch pros:

In the application there is a section called "external trigger setup" where you can select what switch is activated with what trigger. It should look something like below for your application.

Tigger 1: Enabled (or whatever trigger you have going to the high beam)

Active High

Output 1: SW3 (whatever switch you have your lightbar on here)

Output 2: Off

And so on for the rest of the output choices, unless you would like another switch to come on as well.

 

Trying to figure this out as well. I can’t figure out how to get the triggers to work on my

$659 sp9100 switch pros SP-9100 8-switch panel power system with concealed mounting hardware

sp9100. I have the pink trigger wire connected to the dome light fuse with an add-a-fuse and no matter what settings I put they do not come on when the dome lights are on.