MagnaFlow Overland Series Exhaust unboxing, install and sound test

Hey guys, I made a video review for this new exhaust system.

 

Not bad.

Isn’t the exhaust tip a bit too close to the spare?

 

There is about an inch gap...it is a 32" spare. I don't think it will be an issue but I will keep an eye on it.

 

Could also always install a small heat shield if the exhaust will move a bit. Kind of cool it exits like that.

 

Good idea, I’ll look into a small clamp on shield.

 

I like that. It's way down the list but sounds pretty decent for a six. Good video too.

 

great job on the video! sounds good too. Thanks!

 

Drove for about 30 min and the pipe near the tire only got up to 80 degrees. Ambient temp of 46 degrees. Considering tires can handle up to 200 degrees I don’t think I will have an issue. I will keep an eye on it though and might fab up a small shield.

 

How’s the 70mph drone?

 

I don't notice it on the highway unless I'm accelerating.

 

Nice. I like the way it sounds. Do you have a photo of the tip? Does it point directly down or is it angled a bit?

 

a couple strips of bacon should mask that burning rubber smell

 

Not an issue. There is enough clearance and the tip doesn't get very hot. Nowhere near as hot as a tire on summer asphalt.

 

Looks like it’ll hit my @ARCHIVE hammer hanger

 

Cost?

 

Sounds pretty good great video

 

Just rotate the clamped-on elbow so it points down

 

$799

https://www.magnaflow.com/products/...nd-series-cat-back-performance-exhaust-system

 

Easier said than done. Its a long piece.