Looking for alignment shop in corona / riverside area for aftermarket UCA'S

Putting new jba's uca's on my 03 taco looking for alignment shop to get it to specs riverside /corona or closed to this area if possible let me know TW .

Thanks in advance

 

I know you said Corona/Riverside but if you’re willing to travel a bit further Bud’s in Moreno Valley got my numbers pretty good. I’m on Icons/JBAs. I asked them for 3-4 caster with as close to 4 while keeping Toe/Camber @ 0.

Address:
22510 Alessandro Blvd, Moreno Valley, CA 92553

 

Thanks for the info Loung mv not to far got my uca's install now need alignment soon .

 

How much for the alignment @Luong over at mv

 

I think I paid like $130 for 3 year unlimited alignments.

 

Found a Bud's in Riverside same chain looks like it . @Luong

 

Yea, it is a chain and they have them in different locations. I've never been to that one and this is the only Bud's that I've been to so I can't comment on their work.

 

@Luong hay man check out my numbers truck pulls right . Going back today
Should i ask for 0 camber an toe ?
caster equal number

 

I'm honestly not that experienced when it comes to alignment numbers, but it seems like there's quite a difference from your left and right caster as well as your camber on the left vs right.

Maybe someone else can chime in?

 

Yea man aim way off going back today ima try you numbers looks like high caster would be what i need .

Last ? U happen to know exact $ what u pay just wondering cuz i pay over $170 for 3years

so your truck drives nice with this numbers u have ??

 

$143.99 is what my receipt says.

 

Damm over here is 159 for the 3 years how long was urs done .

 

Less than a month ago.

 

Damm thats crazy !!! Ima get my moneys worth jajaja

 

They need to push the rear of the right lower control arm out. It will increase caster and decrease camber. Then adj. toe and center steering wheel. If needed to keep caster numbers even they could do the opposite on the left by pulling the lower rear in. I also would not push for 3.5 degrees of positive caster 2.5-3.0 should work well.

 

Hey whats up Ed yea i got final numbers
The tech say this is the best i can get

 

No pulling rides straight way better ride

 

Yea thanks for checking Ed i just wanted to ride it for a few weeks before i posted final numbers looks like aim good now .ready for some trails e