KC G4 Fog Lights

Just installed these in my 15 Tacoma was in and out and done in 15 minutes. Does anyone know how to adjust the height of the beam? The are 3 Allen Type screws and turning all 3 does absolutely nothing. I have contacted them through this site but never get a response. Can anyone else offer any insight, this is how high they are currently. Just about as high as the headlights

 

Are those the amber ones or did you tint the white ones yellow?

 

Should be one in the back If I remember correctly

https://www.tacomaworld.com/threads...specific-versions.473142/page-4#post-19939124

 

And are the tabs pressed all the way wya into the slots when you mounted them on the truck? I know I hatld to fiddle with mine a bit until they found their way home

 

Yes both went right in without a hitch, both screws soon each side went right back in.

 

Yellow Hella Color Shieldz.

 

When I installed mine I don’t think the adjustment bolt was threaded into the adjustment block, took a few turns to get the threads to catch. The bolt is the one in the middle facing up I think.

 

Should be just one right near dead center back to adjust it. It might even be a Philips now that I think of it. I'll poke my head down there In a second

 

@Taylor@KC HiLiTES

 

Already sent them messages in regards to the this on here. But thanks for tagging them

 

There is that one on the rear, but if I turn out to the left it tightens real fast and the light height does not change. If I move it to the right it loses tension almost immediately and again no light height changes.

 

And trim to size

 

I think this is what I want to get. I dont want to wait for the sae bajas to come out so I think im going to get the white kcs and tint them

 

Got mine yesterday, threw some yellow laminx on them and then put them in. Replaced some amber morimotos.

 

how are they compared to the amber morimotos? I just sold my morimotos to get the KCs

 

Look at the thread on here from all the fog lights these are #1

 

I like them way better. I prefer the yellow to the amber/orange of the morimotos. They’re brighter and the output is taller. The only thing the morimotos have over these is the width of the beam, the moris are so wide.

 

Yeah the morimotos were wide but it was a skinny beam didn't have enough height. And they were so amber if it wasn't foggy or snowing they didnt really help

 

I had the white ones too which were nice but the KC's definitely put out more light. One of my white ones died and i had the ambers laying around so I put those in for a few days