Interior mods?

i would like to see the ashtray mount

 

I have some info here if you would like:

https://www.tacomaworld.com/threads...ve-01-build-thread.290011/page-5#post-9331673

Some thing's I've done:

All blue everything, CB in ash tray, switches mounted to CB.



Vinyl floor and fire extinguisher:

 

Here it is prior to being Plasti-dipped and installed. Two screws. Up through existing screw holes.

 

Sorry if this thread is old, do you have a write up on this dash swap?

 

I just completed the 4runner seat swap. I pulled them out of a 96 4runner SR5 and installed in my 99 tacoma that came with original buckets. The 2 mounts along the transmission tunnel line up. The rear outer is off approximately 1/2 inch but can be forced to line up. The front outer bracket needs to be swapped. I tried using a drill bit but I found it easier to remove the rivet by using a Dremel. After the bracket was swapped, I use a M6x 1.0 x 20mm with lock washers to attached it to the rails.

 

Great! basically what I did but without the dremel. Thanks for the write up

 

How did you get the climate control to light up blue??

 

To make sure the person you're asking sees your question, hit the "Quote" button in the bottom right of their post before asking. They'll be alerted that you quoted them, so they'll know to answer you.

You can change the bulbs behind the climate control cluster and use different colored bulbs, or swap in LED bulbs if you want. They are either type 174 or 94, if I recall correctly. You can do the same behind the gauge cluster for the speedo and tach lights.

 

Where did you get the vinyl floor from? Been looking for a while but I can’t find much

 

I'm curious what you think of it once installed. Been looking at the same floor for the 2gen

 

Here:
https://www.accmats.com/commerce/2001/Toyota/Tacoma/Flooring/16554/

Was way cheaper when I got it though, maybe $150? PITA to install but I love them. My build has a bunch of detailed pics.

 

And here's one for a standard cab for $108

https://www.automotiveinteriors.com/replacement-vinyl-flooring-Toyota-Tacoma-p/acc-v-17079.htm

 

The fit for vinyl floors are not as good as the carpet kits I've found. It's also best to install in the warm summer months.

 

I'm amazed by this mod. I assume you had this done professionally. If not, how easy is it to disassemble the components of the door panel? I would love to replace the dirty fabric on my door!

 

My buddy did the actual upholstering, but I took apart the panels. Super easy. Mostly screws holding the pieces on.

 

I’ve done sound system, dynamat, white led every bulb in the interior (and I mean every bulb). 07 Subaru seats, paracord grab handles and and sides of steering wheel. Paranoid under headunit switch panel and ashtray switch panel, scan gauge, button switches in center console, custom RAM phone mount in drive Pilar with hardwired charger, leds in center console and cup holders, ac control knobs from Amazon,

Out of these I’d say the seats, phone mount, and scan gauge are probably my favorites. I do enjoy the system too

 

Brake & Gas pedal cover and steering wheel cover
toyota motors sticker
wraped glove box theme colors black and red
Bucket seats

 

Overhead console with ham radio

 

This is just awesome. Any installation pictures?

 

Not really. I’m going to upgrade my ham antenna at some point and will have to take the console down to do that. I’ll take more pics then.

In the meantime I have some on my build thread.
https://www.tacomaworld.com/threads/otis24s-build.372874/page-8#post-16094896