Changed speed sensor didn’t fix problem

I have a 1998 Toyota Tacoma SR5 with a manual transmission. It has the 2.7 in it. Went to auto zone to get it scaned because my speedometer, rpm tac, and the digital odometer does not work. The check engine light is on and the po500 speed sensor code showed up. I changed the speed sensor and the speedometer,rpm tac, and odometer still does not work. Any ideas on what could be wrong

 

Possibly the igniter on the Passenger side inner fender

 

Thanks I will check that out

 

Check the wires too and the connections

 

The ECU gets it's speedo signal from the speedometer which is fed by the speed sensor in the trans. If the speedo stops working because something else, it will trip a code for the speedo sensor, even though it isn't the speedo sensor.

Have you checked your fuses?

 

The rpm tach signal comes off the igniter just in case

 

I’ve had problems with autozones sensors mabe try to source oem units ? Possibly do some Continuity test to make sure there no short in the wiring

 

If three of the indicators on the cluster are not working, and it's only three that req'd power, I'd look at the power going to the cluster not the sensors feeding it.

 

Thanks for the response I will check these ideas out and post the outcome