1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Alignment issue, "dog tracking".

Discussion in '2nd Gen. Tacomas (2005-2015)' started by TAC1, Oct 12, 2012.

  1. Oct 12, 2012 at 8:18 AM
    #1
    TAC1

    TAC1 [OP] Well-Known Member

    Joined:
    May 13, 2011
    Member:
    #56594
    Messages:
    2,863
    Gender:
    Male
    First Name:
    Tac1
    Miami, FL
    Vehicle:
    2015 DCSB O/R 4WD
    Hello Forum,

    I have an '08 Prerunner 4.0 that has the following set-up:
    * Billies on all four with front @.85.
    * 2012 Tacoma TRD 2/1 leafs with Wheelers 3 Leaf AAL.

    I installed the new leaf springs with the AAL at the same time & I noticed that my steering wheel was crooked to the right. I found it odd since I did not touch the front. I also noticed that the right rear wheel sticks out about a 1/4 inch more than the left rear wheel. As if the axle is not centered on the vehicle. Today, my friend drove my truck and I drove his car behind him & I noticed that the truck is going down the road with the rear angled towards the right. Its very slight but if you look for it you will see it. The leaf springs were put in correctly. How can I fix this?
     
  2. Oct 12, 2012 at 8:28 AM
    #2
    Pugga

    Pugga Pasti-Dip Free 1983 - 2015... It was a good run

    Joined:
    Jun 18, 2010
    Member:
    #39131
    Messages:
    38,659
    Gender:
    Male
    First Name:
    Mike
    Massachusetts
    Vehicle:
    '19 Ford F-250 6.7 SCrew
    F-250 Land Yacht Mod
    Loosen the u-bolts, re-center the axle (there is a little play where the centering pin goes into the top of the axle) and re-tighten the u-bolts. That's assuming everything else was installed correctly.
     
  3. Oct 12, 2012 at 3:37 PM
    #3
    TAC1

    TAC1 [OP] Well-Known Member

    Joined:
    May 13, 2011
    Member:
    #56594
    Messages:
    2,863
    Gender:
    Male
    First Name:
    Tac1
    Miami, FL
    Vehicle:
    2015 DCSB O/R 4WD
    Pugga, I did just that.

    I had it aligned after and the thrust angle is now 0.6. The mechanic said thats not even noticeable and the alignment itself turned out great. I hope he's right that 0.6 is OK. :)
     
  4. Oct 12, 2012 at 3:44 PM
    #4
    Pugga

    Pugga Pasti-Dip Free 1983 - 2015... It was a good run

    Joined:
    Jun 18, 2010
    Member:
    #39131
    Messages:
    38,659
    Gender:
    Male
    First Name:
    Mike
    Massachusetts
    Vehicle:
    '19 Ford F-250 6.7 SCrew
    F-250 Land Yacht Mod
    So that fixed it for you? That still seems a little high but I don't remember what mine was last time... How's it drive?
     
  5. Oct 12, 2012 at 3:48 PM
    #5
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,674
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    .6 isnt bad. Most vehicles with a live axel very from .9 and lower. anything over 1* is bad (IMHO).
     
  6. Oct 12, 2012 at 6:18 PM
    #6
    Pugga

    Pugga Pasti-Dip Free 1983 - 2015... It was a good run

    Joined:
    Jun 18, 2010
    Member:
    #39131
    Messages:
    38,659
    Gender:
    Male
    First Name:
    Mike
    Massachusetts
    Vehicle:
    '19 Ford F-250 6.7 SCrew
    F-250 Land Yacht Mod
    Good to know. I never paid attention to the thurst angle when they did my alignment :eek:
     
  7. Oct 12, 2012 at 6:20 PM
    #7
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,674
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    With a solid rear axel, its never gonna be a perfect 0*. Not sure why....BUT, One of the reasons its called a "Live Axel", is because it can move from side to side a little bit. This could also contribute to the thrust angle variables.....although, I have never researched into it very deeply.
     
  8. Oct 12, 2012 at 8:01 PM
    #8
    TAC1

    TAC1 [OP] Well-Known Member

    Joined:
    May 13, 2011
    Member:
    #56594
    Messages:
    2,863
    Gender:
    Male
    First Name:
    Tac1
    Miami, FL
    Vehicle:
    2015 DCSB O/R 4WD
    It drives great. I am very happy with it now. Thanks guys for all your advice!
    :)
     
  9. Oct 12, 2012 at 8:01 PM
    #9
    TAC1

    TAC1 [OP] Well-Known Member

    Joined:
    May 13, 2011
    Member:
    #56594
    Messages:
    2,863
    Gender:
    Male
    First Name:
    Tac1
    Miami, FL
    Vehicle:
    2015 DCSB O/R 4WD
    It drives great. I am very happy with it now. Thanks guys for all your advice and info!
    :)
     

Products Discussed in

To Top