3.4l tacoma wire harness diagram

Does anyone have a wiring diagram for a 3.4l tacoma...I just rebuilt the engine and there is a plug that I cant seem to find where it goes...its on the main engine harness and seems to go between the engine and firewall..its a 2 plug female and I need to find the male connector it goes to and I cant find it..

 

Welcome aboard. If it is 2-4 inches out of firewall rt. side of brake booster and your Master cylinder is plugged in it's not needed for your model.

 

1995 toyota tacoma, 3.4l...so was it always just there, but never plugged in? I will try to get a photo later on..do you know if there is a picture of it maybe online or what the plug is called? It's a 2 prong little plug

 

Welcome to TW!!

 

Good afternoon!

 

There wasn't a post I could find but it was discussed with pictures on the 1st gen Lunchtable and BS thread. Plug was black 2 hole female short wire out of harness couple of inches from main harness rt. side firewall by brake booster. Was too short to go past the brake master cylinder.

 

Welcome to TacomaWorld!

 

Welcome to TW!

 

Thanks for the greeting

 

Any ideas on what this could be for?

 

?

 

One more picture from further back - thx. Welcome to TW.

 

These are more photos

 

Could it be a connector maybe more lower?

 

It look to more protect, maybe due to being close to exhaust as well