2023 TRD Sequoia wheels on a 2019 Tacoma ?

Does anyone know the proper wheel spacers to run? I noticed the brake calipers touch inside of wheel . Also the wheel studs are bigger on he Sequoia but the bolt pattern is the same

 

Honestly it looks like a Chevy wheel.

 

What gave it away, TRD on the center cap?

 

Aren't those wheels close to a +60 offset? You're going to need a hell of a spacer to simply restore stock offset.

I'd sell those and get Tacoma sized wheels. Those are going to look wonky after all the overelaborate shoehorning.

 

Don’t do it
Hub bore on the Tundras are 95mm
If you do BORA could make custom spacers

 

They’re 18x8.5 +47.5mm. So about the same outside position, but an extra inch and a half inwards.

A 3/4” spacer would put them close to the same offset as a stock Tacoma wheel.

The Tundra/Sequoia have a smaller hub bore though, so you’ll likely want a custom spacer that goes from 106.1 mm ID on the vehicle side to 95 mm on the wheel side.

Jeff

 

I am trying to determine if these wheels will fit my Taco... They are the Platinum Wheels from the Sequoia, 20" Will there be a HUB problem? by Spec they should fit... Thoughts?

 

read the comments above.

 

Giant wheel spacers make me nervous, get some wheels that fit properly.

 

I See. I thought since these were the "Toyota" branded wheels... they may have proper offset. I may just have to keep hunting for 18" then

 

Chevy wheels (Colorado ZR2 specifically) have the phallic like shapes on them pointing at the bowtie center cap!