00 Honda Odyssey Wheels

Does anyone know if the Honda Odyssey wheels will directly bolt on to a 2nd Gen 5 lug? I looked through the forums but I've only seen one person with them but they have not replied. What my main concern is the center bore size and offset of the wheel.

 

Id make sure that the lug pattern is 5x4.5 as for offset I can't quite remember but that can be pretty much be resolved with a spacer

@HackD
#HackDGotThis

 

2000 Odyssey: 215/65R16 7Jx16 ET40 5x114.3 M12 x 1.5 64.1

Stud pattern, diameter and thread pitch, indicated sizing is the same. Offset is +40mm. Stock Tacoma 5-lug is +45mm. Center bore is 64.1mm. The 5-lug Taco's are 60.1mm Center bore. The Taco hub is meant to be hub-centric, so you are going to need a set of hub-ring adapters to keep the rims centered and balanced. http://www.hubcentric-rings.com/size-64.1-60.1/

Otherwise, on paper, this looks like a direct swap to the Taco. My aftermarket rims have the same specs - the center bore being different (73.1mm).

The rims will be good for up to 245's. I presently run LT225/75R16 Wrangler ST's with no interference or rubbing. No black fenderwell box-delete required for this size. I intend to go up to LT235/85R16 eventually, with the 7Jx16 rim size - which will require the black-box delete.

 

^^^^^ #HackDGotThis ^^^^^

 

Thank you so much for the info!! I was just doing research online but something told me to come check my thread again. #HackD really does got this! Thanks again.